Applied-engineering RamKeeper Instrukcja Użytkownika Pobierz pdf (Strona 20)

Attaching the Optional SlotMover

The SlotMover is an extension board that shifts the

expansion board on the front side of the RamKeeper so

that it wont block slot 7. (Slot 7 is commonly used for

hard drive controller cards.)

Its new position is between slots 4 and 5. Because 4 is the

mouse port and 5 is the disk drive port, you’ll probably

never want to put a card in either.

A) First, lay the RamKeeper face up on the table.

B) Notice the white pegs in two holes of the

RamKeeper’s front connector. (See picture on

page 8.)

C) Push the SlotMover pins into the holes between

these two pegs.

Insert SlotMover into connector

D) Push until SlotMover pins are completely seated

Don’t insert a card in the SlotMover until you have

plugged RamKeeper into the Memory Expansion Slot.

Chapter One - Getting Started 11

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 70 71

Brak uwag

Applied-engineering RamKeeper Instrukcja Użytkownika Strona 20